How To Reset Throttle Position Sensor Honda

How To Reset Throttle Position Sensor Honda. Resetting the throttle position sensor is a very simple process, so it’s worth trying out these methods before going to a mechanic’s. Now repeat the steps mentioned above at least 3 to 4 times.

Dorman 911753 Acura/Honda Throttle Position Sensor from autoplicity.com

I have gone through the flow chart, replaced the tps, done continuity checks, and now replaced the ecu. Remove the sensor electrical connector. Navigate to the “tp position check” on foxwell

Source: www.s2ki.com

When the throttle position sensor is repaired or replaced, it will need to have the minimum idle speed reset to factory specs, and the trouble codes will need to be cleared. David caballero , david, maybe just try this first, unhook your negative cable on battery for 5 minutes or remove ecu fuse from under hood fuse box for 5 minutes, put fuse back or reconnect battery and this will reset ecu.

Source: www.youtube.com

I had a trouble code (13 flashes) and the book indicates a throttle position sensor issue. Shops perform a honda throttle body reset with a scan tool, but you can do it manually by following this procedure:

Source: honda-tech.com

#8 · feb 2, 2010. Idle relearn for slightly open throttle and then this for the extreme position of wot.

Source: autoplicity.com

2) start the engine and run it. I have gone through the flow chart, replaced the tps, done continuity checks, and now replaced the ecu.

Source: www.youtube.com

When the throttle position sensor is repaired or replaced, it will need to have the minimum idle speed reset to factory specs, and the trouble codes will need to be cleared. Thread each 5 mm bolt (16 mm in length) into the slots that secure the tps.

Source: www.youtube.com

Don’t attempt this if you’re uncomfortable working with electricity, as removing the wrong fuse or cable from your battery could be dangerous. Try that and see if it sorts it.

Thread Each 5 Mm Bolt (16 Mm In Length) Into The Slots That Secure The Tps.

I have gone through the flow chart, replaced the tps, done continuity checks, and now replaced the ecu. Don’t attempt this if you’re uncomfortable working with electricity, as removing the wrong fuse or cable from your battery could be dangerous. You want completely depress the accelerator pedal very hard and fully release the accelerator pedal as quickly as possible 5 times within 5 seconds.

2) Start The Engine And Run It.

Idling issues should disappear easily, but if you’re facing unresponsive throttle and inconsistent performance, your throttle position sensor might need a replacement. When the throttle position sensor is repaired or replaced, it will need to have the minimum idle speed reset to factory specs, and the trouble codes will need to be cleared. If you have done this kindly respond with what you experienced, if anything.

Will Output 0Vdc To 5Vdc And The Hall Sensor Will Output 8Vdc To 43Vdc.

Disconnect the negative battery cable. On my 12r it was a case of setting rpm to around 2k with the idle speed adjuster. Connect your scanner to the obd2 port under your dash.

This Function Will Check If The Tp Learning Value Is Within Limits.

The throttle position sensor is a potentiometer that measures the amount of throttle opening. How to reset throttle position sensor. Choose “tp position reset” function.

Make That The Accelerator Pedal Is Completely Released Or Free, Then Turn “On” Ignition Switch And Wait For 3 Seconds.

I had a trouble code (13 flashes) and the book indicates a throttle position sensor issue. Select car region, in this case, select “general” then “diagnose”. There are either two torx screws or two machine screws holding the tps in place, depending on which model you have.