Skip to content Skip to sidebar Skip to footer
Home / 2012 / jeep / pressure / replace / sensor / wrangler

How To Replace Oil Pressure Sensor 2012 Jeep Wrangler

Post a Comment

How To Replace Oil Pressure Sensor 2012 Jeep Wrangler. If i stomp on it the oil pressure will go up but then go then return to 30psi. Locating the oil pressure sending unit.

Removing the intake manifold, on the Pentastar 3.6 Jeep
Removing the intake manifold, on the Pentastar 3.6 Jeep from www.wranglerforum.com

When i start the jeep the oil pressure registers at 30psi. #2 · dec 7, 2008. Clean out all old oil from the oil filter/cooler housing mounting valley.

Disconnect And Isolate The Negative Battery Cable.


If i stomp on it the oil pressure will go up but then go then return to 30psi. Don't eat the snow where the huskies go! The vehicle is raised and supported on jack stands and tire is removed.

Where Is The Oil Pressure Sensor/How Do You Change It On A 4.0?


Choose top quality brands dorman, mopar. In this video, we're going to show you how to replace the oil pressure sensor on this 2004 jeep liberty with the 3.7 liter v6 engine. Here are the steps a mechanic would take to manually diagnose p0520 in your jeep wrangler.

On My 94 It Was Located Just In Front Of The Distributor And Is Threaded Into The Engine Block.


Locating the oil pressure sending unit. Drop it off at our shop and pick it up a few hours later, or save time and have our delivery mechanics come to. It's next to the dipstick tube.

It Is Under The Intake Manifold.


I've cleared it both times and it seems to stay off for about 2 weeks. The defective oil pressure sensor is removed. The items you'll need for this include a new oil pressure sensor from 1aauto.com, a right angle pick, a 27mm socket and ratchet with an extension, and a drip pan.

Maneuver The Oil Filter/Cooler Housing Up And Out, Once Free Of The Engine Unplug The Wiring For The Oil Pressure Sensor And Oil Temperature Sending Unit On The Back Of The Housing And The Pinch Clamp For The Cooling Line 29.


The average cost for a jeep wrangler oil pressure sensor replacement is between $181 and $213. When i start the jeep the oil pressure registers at 30psi. This gives the driver time to pull over and assess the problem before costly repairs become necessary.

Post a Comment for "How To Replace Oil Pressure Sensor 2012 Jeep Wrangler"